Skip to main content
Spring Cleaning Sale - Big Savings!
Motor Life Events Community Support
ASK OUR EXPERTS
1-866-464-6553

Pulsar XT Support

Select Pulsar XT SKU Below

Pulsar XT

12452/12451 Ford Bronco/F150

  • Amber DRLs – This allows you to use the Amber lights as your DRLs and turn signals. Stock, they are used only as turn signals. NOTE: DRLS will not be amber when your high beams or low beams are on.
  • Auto Start Stop Disable – Disables or enables the auto start stop system on vehicles already equipped with it.
  • Battery Management System – Disables BMS. This will allow the battery to charge above the preset threshold. The vehicle will no longer warn you if your battery is getting low due to your headlights or radio being on. The side effect of disabling this system is the auto start stop system will also be disabled.
  • Dark Mode – Interior lights will remain off when the doors are opened.
  • Daytime Running Lights – Enable/disable DRLs
  • DTC Read/Clear - Feature will scan vehicle for Diagnostic Trouble Codes and report any found. Clear command will delete any present codes in the system
  • Emissions Readiness - This feature will check the current status of vehicles emissions readiness monitors.
  • Fog Lights with High Beams - Enables fog lights to stay on with high beams.
  • Headlamp Switch – The stock setting is for the vehicle to put the headlamp switch to “auto” when the vehicle is turned on. This will allow the vehicle to remember the previous setting after a key cycle.
  • Honk Warning – No longer honks if you leave the vehicle with the key if the engine is running.
  • Remote Start Duration – Change duration to 0, 5, 10, or 15 minutes.
  • Tire Size - Allows speedometer and odometer calibration for tire size changes up to 37" tall (36.25" measured). For most accurate results, measure tire height mounted on vehicle with a tape measure and input that reading, not what is printed on tire sidewall.
  • TPMS Adjust - Allows factory TPMS warning threshold to be adjusted between 1-99 psi. Use this feature if wanting to run lower than factory tire pressure
  • TPMS Disable - This feature will completely turn off the TPMS system, use when running below 25psi or if tires are no longer equipped with TPMS sensors.

42455 Jeep 3.0L Diesel

  • APP Levels - Accelerator Pedal Position sensitivity can be adjusted in each power level. Through the phone app, select 'edit' next to the power level and user can adjust APP sensitivity to their preference. Once selected, close the phone app, re-open app and enter power level screen to confirm new selection was saved.
  • Axle Locker - Enable the axle locker feature through the phone app to add additional functionality listed below
  • Rear Locker - With vehicle running and not moving, press the rear axle locker button on the dash. Rear locker light on dashboard will begin flashing, then illuminate solid once axle lock is engaged. Dash will also display notification message.
  • Front/Rear Locker - With vehicle running and not moving, press the Front+Rear axle locker button on the dash. Light on dashboard will begin flashing, then illuminate solid once axle lock is engaged. Dash will also display notification message.
  • Cancel Locker - Press the cancel button to disengage Lockers after either Rear or Front+Rear engagement. Locker light will flash then disappear once unlock is successful.
  • Button Recall - When enabled using the mobile app this feature will recall the last state of the Auto Start Stop button.
  • DTC Rear/Clear - This feature will read vehicles Diagnostic Trouble Codes and clear upon command.
  • Emissions Readiness - This feature will check the current status of vehicles emissions readiness monitors.
  • DPF Regen - Engine temperature must be above 160F, fuel level should be above 15%, vehicle must be in park, and foot off the brake to start a manual regen. Pressing the brake pedal will stop the regen service.
  • Gear Ratio - Axle gear ratio can be adjusted from 2.730 to 5.38, this is only to be adjusted when ring and pinon gear have physically been changed from stock.
  • ECT Protect - Cold engine protection limits Pulsar XT power adding overstock until Engine Coolant Temperature reaches 120-degree F and can begin pulling back power if vehicle reaches 235-degrees
  • High Idle - To enable the high idle feature. With engine on, in Park with your foot off the brake, turn cruise control ON, then use the +/- buttons to increase or decrease the idle RPM. To cancel high idle, turn cruise control OFF or press the brake.
  • Daytime Running Light Location - This feature will allow the adjustment to set which lights to be the daytime running lights. Daytime running lights can be set to fog lights, fender lights, low beams, turn signals, or no daytime running lights.
  • DRL Dropout - Enables daytime running light to stay on during signaling. Feature disabled allows DRL to turn off during signaling.
  • Fog Light Dropout - Enables fog lights to stay on with high beams.
  • License Plate Light Dropout - This feature will turn off your license plate lights when in reverse, to help reduce glare on the backup camera.
  • Turn Signal Light Dropout - This feature will turn off the daytime running light when the blinker is activated. Only turns off the daytime running light on the side the blinker is on.
  • Power Level - With cruise control off, pressing cruise cancel button will display current power level on factory gauge cluster. The '+' and '-' buttons will change power levels at any time while driving or parked. With cruise control enabled, cruise buttons will still function as stock. Power Levels can also be adjusted within the phone app under the Power Level tile.
  • Sway Bar - This feature allows disconnection of the sway bar in 2WD, 4WD high, and 4WD low. To use this feature enable using the mobile app then turn off cruise control, then press and hold the cruise RES button for 5 seconds to disconnect/reconnect the sway bar. The sway bar will automatically reconnect at speeds over 45 MPH.
  • Transfer Case Ratio - Feature allows the transfer case low ratio to be adjusted between (2.72-5.00) if the transfer case gears have physically been changed.
  • Tire Size - Allows speedometer and odometer calibration for tire size changes up to 40" tall. For most accurate results, measure tire height mounted on vehicle with a tape measure and input that reading, not what is printed on tire sidewall.
  • TPMS Adjust - Allows factory TPMS warning threshold to be adjusted between 25-99 psi. Use this feature if wanting to run lower than factory tire pressure.
  • TPMS Disable - This feature will completely turn off the TPMS system, use when running below 25psi or if tires are no longer equipped with TPMS sensors.
  • TC Kill - When enabled using the mobile app. This feature will allow the traction control, electronic stability control, and ABS to be fully disabled. Press and hold the traction control button on the dash for 5 seconds while stopped. To reenable traction control press the traction control button, then turning the key off and back on.

32455 Ram 3.0L Diesel

  • APP Levels - Accelerator Pedal Position sensitivity can be adjusted in each power level including stock. To adjust the APP sensitivity go to the Power Level tile, then to the right of each power level there is a throttle adjust box per each power level. Select the box on the right of the Power Level and select the new APP level desired.
  • Button Recall - When enabled using the mobile app. This feature will recall the last state of the Tow Haul Button, elimination the need to push the Tow Haul Button button every key cycle.
  • DTC Rear/Clear - This feature will read vehicles Diagnostic Trouble Codes and clear upon command.
  • Emissions Readiness - This feature will check the current status of vehicles emissions readiness monitors.
  • Display Gear - This feature enables a menu “Current Gear” in the screen setup of the instrument cluster. This will display the current gear without having to go into manual mode.
  • DPF Regen - Engine temperature must be above 160F, fuel level should be above 15%, vehicle must be in park, and foot off the brake to start a manual regen. Pressing the brake pedal will stop the regen service.
  • ECT Protect - Power is added incrementally as the engine comes up to operating temperature. Gradually adds power from 120F to 150F. Removes added power from 240F to 250F to protect the engine.
  • Fog Light with High Beam - This feature will allow use of the high beams and fog lights at the same time. Without this feature the fog lights will drop out when using the high beams.
  • Gear Ratio - Axle gear ratio can be adjusted from 2.73 to 5.38, this is only to be adjusted when ring and pinon gear have physically been changed from stock.
  • High Idle - To enable the high idle feature. With engine on, in Park with your foot off the brake, turn cruise control ON, then use the +/- buttons to increase or decrease the idle RPM. To cancel high idle, turn cruise control OFF or press the brake.
  • Power Level - With cruise control off, pressing cruise cancel button will display current power level on factory gauge cluster. The '+' and '-' buttons will change power levels at any time while driving or parked. With cruise control enabled, cruise buttons will still function as stock. Power Levels can also be adjusted within the phone app under the Power Level tile.
  • T-case Low Ratio - Feature allows the transfer case low ratio to be adjusted between (2.72-5.00) if the transfer case gears have physically been changed.
  • Tire Size - Allows speedometer and odometer calibration for tire size changes up to 40" tall. For most accurate results, measure tire height mounted on vehicle with a tape measure and input that reading, not what is printed on tire sidewall.
  • TPMS Adjust - Allows factory TPMS warning threshold to be adjusted between 25-99 psi. Use this feature if wanting to run lower than factory tire pressure.
  • Traction Control Kill - When enabled using the mobile app. This feature will allow the traction control, electronic stability control, and ABS to be fully disabled. Press and hold the traction control button on the dash for 5 seconds while stopped. To reenable traction control press the traction control button, then turning the key off and back on.

32456 Ram 5.7L Hemi

  • Tire Size

Back To Top